Key Properties
PFAS-freeMicroplastic-freeWater-basedLeaves no sealing layer, coats each fibre individuallyKeeps the fabric breathable
About Durecon 6000
Durecon 6000 Textile Impregnation is suitable for virtually all materials: synthetic fibres (nylon, polyester, etc.) and natural fibres (linen, cotton, etc.). Because it does not leave a sealing layer but coats each fibre individually, the breathability of the fabric is fully retained.
Technical Specifications
| Property | Specification |
|---|---|
| Appearance | Colourless liquid |
| Odour | Characteristic |
| pH | 5 |
| Relative density (20 °C) | 0.98 g/ml |
| Flash point | > 60 °C (closed cup) |
| Boiling point | 100 °C |
| Viscosity (20 °C) | < 20.5 mm²/s |
| Solubility in water | Soluble |
Application
Suitable Materials
- Synthetic fibres (nylon, polyester, etc.)
- Natural fibres (linen, cotton, etc.)
Directions for Use
- 1Make sure the fabric is clean and dry before treatment.
- 2Apply the impregnation generously and evenly.
- 3Let it dry thoroughly. Optimal results are achieved after 24 hours of drying.
Safety & Handling
- Not classified as hazardous under Regulation (EC) No 1272/2008 (CLP); no hazard pictograms or signal word required.
- Use in well-ventilated areas and do not inhale mist or vapour.
- Avoid contact with the eyes and unnecessary contact with the skin.
Packaging & Storage
Available in 500 ml, 1 L, 5 L, 20 L and 1,000 L. Suitable packaging materials are plastic (PE/PP) and stainless steel. Store frost-free, cool, dry, and well-ventilated in the original, closed packaging.
Downloads
Technical Data Sheet (TDS)
PDF · v1.0 · 2026-04-08